【BS英國標準】BS EN 46241995 無損檢驗——射線圖像質量 第4部分：圖像質量靈敏度和行幀度的試驗評定

《【BS英國標準】BS EN 46241995 無損檢驗——射線圖像質量 第4部分：圖像質量靈敏度和行幀度的試驗評定》由會員分享，可在線閱讀，更多相關《【BS英國標準】BS EN 46241995 無損檢驗——射線圖像質量 第4部分：圖像質量靈敏度和行幀度的試驗評定（12頁珍藏版）》請?jiān)谘b配圖網上搜索。

1、 國內外標準 大全 豆丁網國內外標準下載地址 BRITISH STANDARD BS EN 462-4:1995 Non-destructive testing — Image quality of radiographs — Part 4: Experimental evaluation of image quality values and image quality tables

2、 The European Standard EN 462-4:1994 has the status of a British Standard BS EN 462-4:1995 Committees responsible for this British Standard The preparation of this British Standard was entrusted to Technical Committee WEE/46, Non-destructive testing, upon which t

3、he following bodies were represented: Aluminium Federation Associated Offices Technical Committee Association of Consulting Engineers BNF (Fulmer Materials Centre) British Airways British Chemical Engineering Contractors’ Association British Coal Corporation British Gas plc British Institu

4、te of Non-destructive Testing British Non-ferrous Metals Federation British Nuclear Fuels plc British Railways Board British Steel Industry Department of Trade and Industry (NAMAS Executive) Electricity Association Engineering Equipment and Materials Users’ Association Health and Safety Exec

5、utive Institute of Physics Institute of Quality Assurance Light Metal Founders’ Association Lloyd’s Register of Shipping Ministry of Defence National Radiological Protection Board Power Generation Contractors’ Association (PGCA (BEAMA Ltd.)) Railway Industry Association of Great Britain Royal

6、Society of Chemistry Society of British Aerospace Companies Limited Society of Motor Manufacturers and Traders Limited Steel Casting Research and Trade Association Welding Institute This British Standard, having been prepared under the direction of the Engineering Sector Board (E/-), was

7、published under the authority of the Standards Board and comes into effect on 15 April 1995 ? BSI 12-1998 The following BSI references relate to the work on this standard: Committee reference WEE/46 Draft for comment 91/83302 DC ISBN 0 580 28865 2 The following bodies were also rep

8、resented in the drafting of the standard, through subcommittees and panels: British Photographic Association National Nuclear Corporation Ltd. Amd. No. Date Comments Amendments issued since publication BS EN 462-4:1995 Contents Page Committees re

9、sponsible Inside front National foreword ii Foreword 2 Text of EN 462-43 3 List of references Inside back cover ? BSI 12-1998 i BS EN 462-4:1995 National forew

10、ord This British Standard has been prepared by Technical Committee WEE/46 and is the English language version of EN 462-4: 1994 Non-destructive testing — Image quality of radiographs — Part 4: Experimental evaluation of image quality values and image quality tables, published by the European

11、 Committee for Standardization (CEN). EN 462-4:1994 was produced as a result of international discussion in which the UK took an active part. Cross-references Publication referred to Corresponding British Standard BS EN 462 Non-destructive testing — Image quality of radiographs EN 462-

12、1 Part 1:1994 Image quality indicators (wire type) — Determination of image quality value EN 462-2 Part 2:1994 Image quality indicators (step/hole type) — Determination of image quality value A British Standard does not purport to include all the necessary provisions of a contract. Users of Bri

13、tish Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cove

14、r, pages i and ii, the EN title page, pages 2 to 4, an inside back cover and a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front cover. ? BSI 12-1998 ii EUROPEAN STA

15、NDARD NORME EUROPéENNE EUROP?ISCHE NORM EN 462-4 November 1994 ICS 19.100 Descriptors: Non-destructive tests, industrial radiography, photographic images, quality, image quality indicators English version Non-destructive testing — Image quality of radiographs — Par

16、t 4: Experimental evaluation of image quality values and image quality tables Essais non destructifs — Qualité d’image des radiogrammes — Partie 4: Evaluation expérimentale des indices de qualité d’image et des tables de qualité d’image Zerst?rungsfreie Prüfung — Bildgüte von Du

17、rchstrahlungsaufnahme — Teil 4: Experimentelle Ermittlung von Bildgütezahlen und Bildgütetabellen This European Standard was approved by CEN on 1994-11-10. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European

18、Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CEN member. This European Standard exists in three official versions (Engl

19、ish, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions. CEN members are the national standards bodies of Austria, Bel

20、gium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. CEN European Committee for Standardization Comité Européen de Normalisation Europ?isches Komitee für Normung

21、Central Secretariat: rue de Stassart 36, B-1050 Brussels ? 1994 Copyright reserved to CEN members  Ref. No. EN 462-4:1994 E EN 462-4:1994 3 ? BSI 12-1998 Foreword This European Standard has been produced by CEN/TC 138 Non-destructive testing, the secretariat o

22、f which is held by the French Association for Standardization (AFNOR). EN 462-4 is a Part of a series of European Standards with the same number; the other Parts are the following: EN 462-1, Non-destructive testing — Image quality of radiographs — Part 1: Image quality indicators (wire type) — De

23、termination of image quality value. EN 462-2, Non-destructive testing — Image quality of radiographs — Part 2: Image quality indicators (step/hole type) — Determination of image quality value. EN 462-3, Non-destructive testing — Image quality of radiographs — Part 3: Image quality classes for fe

24、rrous metals. EN 462-5, Non-destructive testing — Image quality of radiographs — Part 5: Image quality indicators (Duplex wire type) — Determination of total image unsharpness value. This European Standard shall be given the status of a national standard, either by publication of an identica

25、l text or by endorsement, at the latest by May 1995, and conflicting national standards shall be withdrawn at the latest by May 1995. According to the CEN/CENELEC Internal Regulations, the following countries are bound to implement this European Standard: Austria, Belgium, Denmark, Finland, Fran

26、ce, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. Contents Page 1 Scope 3 2 Normative references 3 3 Definitions 3 4 Experimental evaluation of image quality values 3 5 Determination of image

27、 quality tables 3 Foreword 2 Figure 1 — Example for the determination of an image quality table 4 Table 1 — Example of an image quality table 4 1 Scope This standard gives instructions for the determination of image quality values and image qualit

28、y tables. If the IQI requirements from Part 3 of this standard cannot be used, because, for example, the absorption coefficients of the IQI material and the inspected material differ by more than 30 %, test exposures are necessary to determine acceptance of image quality values. The image quality

29、values achieved by the test exposures are required for all exposures made under the same radiographic conditions. 2 Normative references This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate

30、 places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication

31、 referred to applies. EN 462-1, Non-destructive testing — Image quality of radiographs — Part 1: Image quality indicators (wire type), determination of image quality value. EN 462-2, Non-destructive testing — Image quality of radiographs — Part 2: Image quality indicators (step/hole type), dete

32、rmination of image quality value. EN 462-3, Non-destructive testing — Image quality of radiographs — Part 3: Image quality classes for ferrous metals. 3 Definitions For the purposes of this standard, the following definitions apply. 3.1 image quality indicators (IQI) see EN 462-1 and EN 4

33、62-2 3.2 image quality see EN 462-1 and EN 462-2 3.3 image quality value see EN 462-1 and EN 462-2 3.4 image quality table achieved image quality values versus the penetrated wall thickness (see clause 4) 4 Experimental evaluation of image quality values For the experimental determinat

34、ion of image quality values, the same radiographic conditions and IQI shall be used as specified for the subsequent examination. Two test exposures shall be made under the specified conditions. If the image quality values read from these two exposures are identical, this value shall be accepted as

35、 the required image quality value. If the image quality values from the two test exposures are different, the procedure shall be repeated. 5 Determination of image quality tables If different wall thicknesses of the same material are radiographed, an image quality table shall be established. An

36、example of the image quality values for different penetrated thicknesses according to clause 4 is shown in Figure 1. The step curve below the experimental values defines the image quality values and penetrated thickness steps of the image quality table, for an example see Table 1.

37、 Figure 1 — Example for the determination of an image quality table Table 1 — Example of an image quality table Penetrated thickness w mm Image quality value Up to 2 A Above 2 to 3 B Above 3 to 5 C Above 5 to 10

38、 D Above 10 to 20 E Above 20 to 40 F Above 40 G BS EN 462-4:1995 List of references See national foreword. ? BSI 12-1998 BSI 389

39、 Chiswick High Road London W4 4AL | | | | | | | | | BSI D British Standards Institution | | | | | | | BSI is the independent national body responsible for preparing British Standards. It | | | presents the UK view on standards in Europe and at the international level. It i

40、s | incorporated by Royal Charter. | | | Revisions | | | British Standards are updated by amendment or revision. Users of British Standards | | should make sure that they possess the latest amendments or editions. | | It is the constant aim of BSI to improve the quality of our produ

41、cts and services. We | | | would be grateful if anyone finding an inaccuracy or ambiguity while using this | | British Standard would inform the Secretary of the technical committee responsible, | the identity of which can be found on the inside front cover. Tel: 020 8996 9000. | | Fa

42、x: 020 8996 7400. | | | BSI offers members an individual updating service called PLUS which ensures that | subscribers automatically receive the latest editions of standards. | | | Buying standards | | | | Orders for all BSI, international and foreign standards publications should

43、 be | addressed to Customer Services. Tel: 020 8996 9001. Fax: 020 8996 7001. | | | In response to orders for international standards, it is BSI policy to supply the BSI | | implementation of those that have been published as British Standards, unless | otherwise requested. | | | In

44、formation on standards | | | | BSI provides a wide range of information on national, European and international | standards through its Library and its Technical Help to Exporters Service. Various | | BSI electronic information services are also available which give details on all its

45、 | | products and services. Contact the Information Centre. Tel: 020 8996 7111. | Fax: 020 8996 7048. | | | | Subscribing members of BSI are kept up to date with standards developments and | | receive substantial discounts on the purchase price of standards. For details of | these an

46、d other benefits contact Membership Administration. Tel: 020 8996 7002. | | Fax: 020 8996 7001. | | | Copyright | | Copyright subsists in all BSI publications. BSI also holds the copyright, in the UK, of | | | the publications of the international standardization bodies. Except as

47、permitted | | under the Copyright, Designs and Patents Act 1988 no extract may be reproduced, | stored in a retrieval system or transmitted in any form or by any means ± electronic, | | photocopying, recording or otherwise ± without prior written permission from BSI. | | | This does n

48、ot preclude the free use, in the course of implementing the standard, of | necessary details such as symbols, and size, type or grade designations. If these | | | details are to be used for any other purpose than implementation then the prior | written permission of BSI must be obtained. | | | If permission is granted, the terms may include royalty payments or a licensing | | agreement. Details and advice can be obtained from the Copyright Manager. | | Tel: 020 8996 7070. | | | | | | | | | | | | | | | | | | | | |